What you need:
thin plastic
sheet metal
metal saw
drill
screw driver thats fits your screws
various drill bits
2 x 1cm long nuts
2 x bolts
2 x 1.5cm long screws
1. start off buy cutting the sheet metal to a size the will fit nicely around the barrel of the recon.
2. cut the plastic to a size that will fit between the cocking handle and the new foregrip.
3. drill a hole the same size as your bolt bolt in the middle of the metal 1cm from the top.
4. drill a hole the same size as your bolt bolt in the middle of the plastic 1cm from the edge then do the same on the other end but the same size as your screw.
5. put the metal in place then put a piece of plastic on each side of the barrel on the outside of the metal ,then put the screw through and tighten.
6.finally put the other end of the plastic on the cocking handle then screw through the hole into the plasctic.
[
b]7.[/b] Also you can put a piece over the top like i i am working on.
Thanks guys and please comment