I've been looking for K26 springs for ages now and i've finally sourced a large quantity.
Since they're in America, the postage is pretty bad but if people want, i can bring them into the country for roughly $12 a piece + domestic shipping. If more people are interested, I may lower the price as the shipping decreases.
INFO: These springs pretty beafy from my knowledge and are 11inches long and may be cut down to fit many different blasters and these are perfect for; homemades, +bows, longshots, cut down in NF's, ERTL PAS and not too sure on any more.
POST YOUR INTEREST.
...Interest so far...
-Silent Scope x 3 PAID
-Berge x 2 PAID
-Oxymoron x 2 PAID
-sd_type x 1 PAID
-2120 x 1 PAID
-Unknown x 1
-matt.chopper x 3
-KingCam x 4
Continuous-Length Compression Springs
System of Measurement
Coils Per Inch
To determine how many inches long your spring should be, take the spring constant and divide it by the number of coils per inch. Then take this value and divide it by your desired spring rate in lbs./inch. To cut spring, use an abrasive cutoff saw.
Last edited by melbnerf619 on Thu Sep 22, 2011 9:27 am; edited 15 times in total (Reason for editing : names added)