Hai guys,
I managed to get a the hunter twin pack and I did a simple mod to one of them.
Materials
- E-tape
- Lube
- Spring (optional)
- A length of 15mm
Tools
- Drill
- Screw drivers
- Hammer
First, take out all the screws, all are the same except one, a larger screw will be in the bottom of the stock. After that remove the plunger tube and bolt. Remove the screws that hold the bolt and plunger together also
Next Drill out the AR
Next, E-tape under the O-ring and hammer out the pin at the rear of the plunger rod and add a spring (I was about to swap for an NF gen 2 spring but i was like nahh at the last minute)
Finally, put it together and inserted a decent length of pvc, that fits perfectly, into the front barrel for a barrel extension.
Before the range was awful, now they are decent. Once I get more materials I will mod it further, paint it and add a scope, but this is all for now.
Evo out >.>
I managed to get a the hunter twin pack and I did a simple mod to one of them.
Materials
- E-tape
- Lube
- Spring (optional)
- A length of 15mm
Tools
- Drill
- Screw drivers
- Hammer
First, take out all the screws, all are the same except one, a larger screw will be in the bottom of the stock. After that remove the plunger tube and bolt. Remove the screws that hold the bolt and plunger together also
Next Drill out the AR
Next, E-tape under the O-ring and hammer out the pin at the rear of the plunger rod and add a spring (I was about to swap for an NF gen 2 spring but i was like nahh at the last minute)
Finally, put it together and inserted a decent length of pvc, that fits perfectly, into the front barrel for a barrel extension.
Before the range was awful, now they are decent. Once I get more materials I will mod it further, paint it and add a scope, but this is all for now.
Evo out >.>