How to Re-barrel a Maverick

Lets Start
OK what you need:

- PETG (available form Inf0rm3r)
- Hot-Glue and Gun
- Dremel or File

Ok, first off get your Maverick and take it apart and then take the turret out.



Now take the turret fully apart and take the AR's out.



Now get this part and cut it at the top where the hole is the largest, like the picture shows.



Now get your Dremel or file and sand down the little nubs.



Now measure the PETG tot he right size and then push the PETG into the holes and use some hot-glue to seal it all up.





Now do the other regular mods like the penny mod and Russian roulette mods and your done

- Brad

If you are going to that effort you may as well make it rear load too.

Psykka wrote:If you are going to that effort you may as well make it rear load too.

Rear loading? Hmm I must have been living under a rock because I didn't know you could make a maverick read loading lol.

TheBradl3s wrote:

Psykka wrote:If you are going to that effort you may as well make it rear load too.

rear loading? hmm i must have been living under a rock because i didn't know you could make a maverick read loading lol

I didn't know you could do that, either. but now that I look at it - it seems quite obvious

You would need to alter the front of the plunger obviously but it's entirely possible. Mainly for the cool revolverness you know.

BANG!

littlebro05 wrote:BANG!

https://www.youtube.com/watch?v=DuSuDZWkkW4

And there you go. Your living under a rockness has been expelled.
Now make that into a nitemav with drop clips or a tri-rotating turret and you would have a very cool pistol.

What are the ranges?

Haven't measured, but for me, for some reason it actually didn't do much still around 20-25ft for me, with a better seal it should be better.

- Brad