Home
I did not actually know where this should go, due to it not being an in production picture set, but I will explain as best I can.
https://i.servimg.com/u/f48/16/98/22/04/dscf1711.jpg
As you can see in this picture it looks remarkably similar to the standard design, the parts are as follows.
Thick wall 13 cm brass (I am using thin wall next time)
25mm coupler.
25mm reducer to 15mm.
A small piece of 15mm pipe.
E-tape and hot glue.
.Step one: cut your brass into roughly 3 pieces of 4-5inch of brass then wrap some e-tape around them to hold them in a bunch.
step two: use a dremel or a rounded file to smooth the inside of your coupler till you can casually slide the three barrels into it (the barrels should stop at the middle of the coupler
https://i.servimg.com/u/f48/16/98/22/04/dscf1713.jpg
step three: seal the holes in between the coupler and the barrels with hot glue to provide good airflow into the barrels
step four: as you have probably gathered is to insert the small 15mm piece of pipe into the reducer
At this stage you will have two components the "adapter" and the "shell"
https://i.servimg.com/u/f48/16/98/22/04/dscf1712.jpg
Ands thats all folks you can rear load blue foam darts into a tri-shot with a 15mm adapter for any couplered blaster.
Im sorry if its a little hard to understand pm or comment in regards to it.
https://i.servimg.com/u/f48/16/98/22/04/dscf1711.jpg
As you can see in this picture it looks remarkably similar to the standard design, the parts are as follows.
Thick wall 13 cm brass (I am using thin wall next time)
25mm coupler.
25mm reducer to 15mm.
A small piece of 15mm pipe.
E-tape and hot glue.
.Step one: cut your brass into roughly 3 pieces of 4-5inch of brass then wrap some e-tape around them to hold them in a bunch.
step two: use a dremel or a rounded file to smooth the inside of your coupler till you can casually slide the three barrels into it (the barrels should stop at the middle of the coupler
https://i.servimg.com/u/f48/16/98/22/04/dscf1713.jpg
step three: seal the holes in between the coupler and the barrels with hot glue to provide good airflow into the barrels
step four: as you have probably gathered is to insert the small 15mm piece of pipe into the reducer
At this stage you will have two components the "adapter" and the "shell"
https://i.servimg.com/u/f48/16/98/22/04/dscf1712.jpg
Ands thats all folks you can rear load blue foam darts into a tri-shot with a 15mm adapter for any couplered blaster.
Im sorry if its a little hard to understand pm or comment in regards to it.
