PB Magnum Blaster (Delin Toys) - Internals

Notes:

To take this gun a part requires to to use a flat blade screw driver and rubber mallet to tap off the two red caps.
DO NOT use a metal hammer as it will destroy the caps and/or gun.
Then just remove the screws. There are no hidden screws and all the same size.

The PB mech looks like a drop loader and the seal on the red cap is to keep the hooper pipe in place.

The reason i opened this blast is because something broke inside, and it was a peice of the priming mech.
It is just two small piece of round plastic with a small melt spike from the priming arm going into both sides of the shell on a indented rail (see third last picture).
Looking to see how i can fix and reinforce this.

See littlebro05 review for information, more photos(assembled) and ranges ...
http://www.oznerf.com/t2020-review-magnum-foam-blaster-black-tactical?highlight=magnum


For additional blaster internal pics, visit the Internals Directory, here:
OzNerf Internals Directory

Just to point it out to those who don't already know, the metal priming bar is rather weak, mine broke after maybe 50 shots (only rebarrelled and with the PB mech removed).

Thanks for pointing that out Bacara : )
Here is a side image to show you the break points we are talking about.



The metal used for the priming bar is very soft and weak.
Mine is also showing signs of breaking where Bacara's broke.

Both of mine broke within maybe 10 mins of opening the packaging...

I'll get around to fixing them one day... lol

Cheers,

Could you just replace it with the wipeout ones?

MIG welder and a bit (ie lots) of care fixes them. Next one I get will probably get welded before I even prime it.

Yeah If you have a wipeout use the that priming rod. That's what I have been doing and no harms done. This is because the wipeout is build with stronger parts in general, the only difference is that it has a weaker spring.