Ok, I did this a while ago but just getting around to post it
unfortunatly i dont have the size for the nylon elbows oe the 4 way joiner so sorry.
cut your 4 way joiner and elbows down as shown in the image above. they should line up perfectly with the ends of your barrels.
They sould look like this
i cut down my barrels to minimise dead space but you could just trim the ends off. i put a small piece of nylon tube over the ends of the elbows before glueing them in to place but you could just fill the gap with hot glue or plumbers goop.
Now take a 20mm pvc T piece and a piece of 20mm pvc pipe cut down line up as shown int this image. connect to your top barrel with a 20mm pvc coupler.
once you get the length right glue the pipe int the T piece then drill a hole to fit the top of the 4 way joiner into like this.
Cut the top off your 20mm T the cut a 20 mm coupler at 45 degrease at one end the glue to top of T couplerso it looks like this
then add your choice of barrel and clip and yout done
hope there was enough info for people. All components for this mod were from bunnings. the barbed joiners i found in the irrigation section.
unfortunatly i dont have the size for the nylon elbows oe the 4 way joiner so sorry.
cut your 4 way joiner and elbows down as shown in the image above. they should line up perfectly with the ends of your barrels.
They sould look like this
i cut down my barrels to minimise dead space but you could just trim the ends off. i put a small piece of nylon tube over the ends of the elbows before glueing them in to place but you could just fill the gap with hot glue or plumbers goop.
Now take a 20mm pvc T piece and a piece of 20mm pvc pipe cut down line up as shown int this image. connect to your top barrel with a 20mm pvc coupler.
once you get the length right glue the pipe int the T piece then drill a hole to fit the top of the 4 way joiner into like this.
Cut the top off your 20mm T the cut a 20 mm coupler at 45 degrease at one end the glue to top of T couplerso it looks like this
then add your choice of barrel and clip and yout done
hope there was enough info for people. All components for this mod were from bunnings. the barbed joiners i found in the irrigation section.